The Plastics Today for the Technologies of Tomorrow

Polycarbonate Material Safety Data Sheet

POLYCARBONATE

Effective DateMay 1, 1996
Revised DateApril 8, 2011
Trade NamePolycarbonate
Chemical FamilyPolycarbonate
Chemical FormulaBisphenol A Polycarbonate
Section II - Hazardous Ingredients
Hazardous ComponentsThis product contains no hazardous ingredients.
Section III - Physical Data
Boiling Point (F)N/A
Freezing Point (F)220–230°C
Volatility / Volume (%)Negligible
Melting Point428–446°F
Vapor Pressure (mmHg)N/A
Vapor Density (Air=1)N/A
Solubility in H2OInsoluble
Appearance / OdorSolid / Slight
Specific Gravity (H2O=1)Approximately 1.2 g/cm³ at 68°F (20°C)
Acidity
Section IV - Fire and Explosion Hazard Data
Flash PointAbove 842°F (450°C)
Lower Flame PointNot established
Higher Flame PointNot established
Extinguish MediaWater, carbon dioxide, dry chemical, foam
For FireFirefighters must wear full emergency equipment with self-contained breathing apparatus.
Unusual Fire HazardIrritating and toxic gases and aerosols may be generated by thermal decomposition and combustion.
Section V - Health Hazard Data
Health HazardCoarse dust and particulates generated during fabrication can irritate the eyes, nasal passages and upper respiratory system.
Threshold Limit Value
Over Exposure Effects
Section VI - Reactivity Data
Chemical StabilityStable
Conditions to AvoidExposure to heat and flame
Section VI - Reactivity Data - Continued
Incompatible MaterialsNone in designed use
Decomposition ProductsCarbon monoxide and carbon dioxide from burning. When heated to decomposition (420°C, 788°F), fumes can contain bisphenol A, methane, diphenyl carbonate and NOx.
Hazardous PolymerizationsWill not occur
Polymerization Avoid
Section VII - Spill or Leak Procedure
For SpillRemove mechanically using a method that minimizes airborne dust generation.
Waste Disposal MethodIncineration or landfill.
Section VIII - Special Protection
Respiratory ProtectionUse a dust mask.
VentilationA NIOSH/MSHA-approved dust respirator is recommended if airborne dust concentration is near or exceeds nuisance-dust exposure requirements.
Protective GlovesGloves are recommended.
Eye ProtectionSafety glasses recommended.
Other Protective Equipment
Handling and StorageStore in a clean, dry environment. Materials must be dried before processing.
Section IX - Special Precautions
Hazard Class
DOT Shipping NameNon-regulated
Reportable Quantity (RQ)None
UN NumberNone
Packaging Size
Notes:
All information, recommendations and suggestions appearing herein concerning this product are based upon data obtained from the manufacturer and/or recognized technical sources. It is the user’s responsibility to determine the safety, toxicity and suitability of their own use, handling and disposal. Since actual use by others is beyond our control, no warranty, express or implied, is made by Polymer Plastics Company L.C. as to effects of such use, results obtained, or the safety and toxicity of the product. Polymer Plastics Company L.C. assumes no liability arising out of use by others of the product referred to herein. The data in this MSDS relate only to the specific material designated herein and do not relate to use in combination with any other material or in any other process.
REFERENCES: N/A = Not Applicable, N/D = Not Determined, N.D.A. = No Data Available